16 | English
1 609 929 W25 | (25.1.10) Bosch Power Tools
Changing the Tool (see figures E1–E3)
f Before any work on the machine itself, pull
the mains plug.
f When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Use only saw blades whose maximum permitted
speed is higher than the no-load speed of the
power tool.
Use only saw blades that correspond with the
characteristic data given in these operation in-
structions and that are tested and marked in ac-
cordance with EN 847-1.
Use only saw blades recommended by the tool
manufacturer, and suitable for sawing the mate-
rials to be cut.
Removing the Saw Blade
– Bring the power tool into the working posi-
tion.
– Completely unscrew screw 35.
Do not lose the snap ring while removing the
screw from the blade guard.
– Push the locking lever 3 and swing the re-
tracting blade guard 4 to the rear to the stop.
– Turn hexagon bolt 37 with the provided ring
spanner 17 and at the same time press the
spindle lock 36 until it engages.
– Keep the spindle lock 36 pressed and un-
screw hexagon bolt 37 in clockwise direction
(left-hand thread!).
– Remove the clamping flange 38.
– Remove the saw blade 5.
Mounting the Saw Blade
If required, clean all parts to be mounted prior
to assembly.
– Place the new saw blade onto the interior
clamping flange 39.
f When mounting the saw blade, pay atten-
tion that the cutting direction of the teeth
(arrow direction on the saw blade) corre-
sponds with the direction of the arrow on
the blade guard!
– Mount the clamping flange 38 and hexagon
bolt 37.
Press the spindle lock 36 until it engages and
tighten the hexagon bolt in anticlockwise di-
rection.
– Push the locking lever 3 and guide the re-
tracting blade guard 4 down again.
– Screw in screw 35 together with the snap
ring and retighten again.
Operation
f Before any work on the machine itself, pull
the mains plug.
Transport Safety (see figure F)
The transport safety-lock 22 enables easier han-
dling of the machine when transporting to vari-
ous working locations.
Releasing the Machine (Working Position)
– Push the tool arm by the handle 2 down a lit-
tle in order to relieve the transport safety-
lock 22.
– Pull the transport safety-lock 22 completely
outward.
– Guide the tool arm slowly upward.
Securing the Machine (Transport Position)
– Push the locking lever 3 and at the same time
move the tool arm by the handle 2 down-
ward.
– Guide the tool arm downward until the trans-
port safety-lock 22 can be pushed complete-
ly inward.
The tool arm is now securely locked for trans-
port.
OBJ_BUCH-1142-001.book Page 16 Monday, January 25, 2010 8:52 AM
To Next Page
Loading...
