28 | English
1 609 92A 1GN | (23.6.15) Bosch Power Tools
Product Description and Specifica-
tions
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
Intended Use
The power tool is intended as a stationary machine for making
straight lengthways and crossways cuts in wood. In this, mitre
angles from –48° to +48° as well as bevel angles from 0° to
45° are possible.
The capacity of the power tool is designed for sawing hard-
wood and softwood.
The power tool is not suitable for cutting aluminium or other
non-ferrous metals or alloys.
Product Features
The numbering of the components shown refers to the repre-
sentation of the power tool on the graphic pages.
1 Handle
2 Laser warning label
3 Lever for releasing the tool arm
4 Blade guard
5 Retracting blade guard
6 Roller
7 Fence
8 Saw table
9 Mounting holes
10 Insert plate
11 Locking knob for various mitre angles
12 Tilt protector
13 Mitre angle indicator
14 Detents for standard mitre angles
15 Scale for mitre angle
16 Fastening screw for stationary saw-table extension 17
17 Saw-table extension (stationary)
18 Adjustable fence
19 Material clamp
20 Laser unit/Laser radiation outlet
21 Bevel lock lever
22 Transport handle
23 Dust bag
24 Adjusting screw of depth stop
25 Depth stop
26 Saw blade
27 On/Off switch
28 Laser on/off switch (for marking of cutting line)
29 Chip ejector
30 Tilt-protector bar
31 Slide device
32 Locking lever of slide device
33 Mounting holes for material clamp
34 Opening for stationary saw-table extension 17
35 Transport safety-lock
36 Opening for flexible saw-table extension 48
(on the power tool)
37 Spindle lock
38 Hex key
39 Clamping lever of the adjustable fence
40 Indicator for bevel angle
41 Scale for bevel angle
42 Fastening screw for tilt-protector bar
43 Hex socket screw for mounting of saw blade
44 Clamping flange
45 Interior clamping flange
Wear a dust respirator.
Wear safety goggles.
Wear ear protectors. Exposure to
noise can cause hearing loss.
Laser Radiation
Do not stare into beam
Class 2 laser product
Danger area! Keep hands, fingers or
arms away from this area.
The adjustable fence
must be pulled outward
when sawing bevel an-
gles.
Observe the dimensions of the saw blade.
The hole diameter must match the tool
spindle without play. Do not use reducers
or adapters.
The cutting line can be in-
dicated by the laser beam
on either the left or right
of the saw blade.
Symbols and their meaning
OBJ_BUCH-2325-002.book Page 28 Tuesday, June 23, 2015 9:26 AM
To Next Page
Loading...
