20 | English
u Keep cutting tools sharp and clean. Properly main-
tained cutting tools with sharp cutting edges are less
likely to bind and are easier to control.
u Use the power tool, accessories and tool bits etc. in
accordance with these instructions, taking into ac-
count the working conditions and the work to be per-
formed. Use of the power tool for operations different
from those intended could result in a hazardous situation.
u Keep handles and grasping surfaces dry, clean and
free from oil and grease. Slippery handles and grasping
surfaces do not allow for safe handling and control of the
tool in unexpected situations.
Service
u Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
Safety instructions for fine spray systems
u Keep your work area clean, well lit and free of paint or
solvent containers, cloths and other flammable mater-
ials. There is a risk of spontaneous combustion. Ensure
that you have access to functioning fire extinguishers or
extinguishing equipment at all times.
u Ensure that the spray area is well ventilated and that
there is sufficient fresh air circulating in the whole
area. Evaporating flammable solvents create an explosive
environment.
u Do not spray or clean with materials with a flash point
lower than 55°C. Use water-based materials, non-
volatile hydrocarbons or similar materials. Volatile
evaporating solvents create an explosive environment.
u Do not spray near ignition sources such as static elec-
tricity sparks, naked flames, pilot lights, hot objects,
engines, cigarettes and sparks created by plugging in
and unplugging electric cables or operating switches.
These kinds of spark sources can lead to combustion of
the surrounding environment.
u Do not spray materials if it is not clear whether they
might be dangerous. Unknown materials could create
hazardous conditions.
u Do not spray boiling water. Spray only warm water
(max. 55°C) which is free from chemical additives.
u Wear additional personal protection equipment such
as appropriate protective gloves and a protective
mask or respirator when spraying or handling chemic-
als. Wearing personal protection equipment appropriate
to the conditions reduces your exposure to hazardous
substances.
u Take note of possible risks posed by the spray mater-
ial. Observe the markings on the container or the man-
ufacturer's information regarding the spray material,
including the instructions about using personal pro-
tective equipment. You must comply with the manufac-
turer's instructions in order to reduce the risk of fire and
of injury caused by poison, carcinogens, etc.
u Keep the mains plug and the spray system trigger
switch free from paint and other liquids. Never hold
the cable by its plug connection for support. Doing this
could cause electric shock.
u Supervise children. This will ensure that children do not
play with the fine spray system.
Products sold in GB only:
Your product is fitted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an au-
thorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Symbols
The sticker regarding operation of the fine-spray system is located on the
base station. The correct interpretation of the symbols helps you operate the
fine-spray system better and more safely.
1 609 92A 84E | (12.07.2022)Bosch Power Tools
To Next Page
Loading...
Need help?
General
