Troubleshooting aus
45
Fault Cause Troubleshooting
E:61-02 will light up altern-
ately.
Cover of the wastewater
pump is loose
▶
Secure the cover of the "Wastewa-
ter pump " →Page54 so it clicks
into position.
E:90-01 will light up altern-
ately.
Mains voltage is too low. This is not a fault on the appliance.
1. Contact an electrician.
2. Have the mains voltage and elec-
trical installation checked by an
electrician.
A different error code ap-
pears in the display window.
E:01-00 to E:90-10
A technical fault is present. 1. Press .
2. Unplug the appliance or switch off
the fuse.
3. Wait at least 2minutes.
4. Insert the mains plug of the appli-
ance in a socket or switch on the
fuse.
5. Switch the appliance on.
6. If the problem occurs again:
‒ Press .
‒ Turn off the water tap.
‒ Pull out the mains plug.
‒ Contact "Customer Service"
→Page55 and give the er-
ror code.
Washing results
Fault Cause Troubleshooting
Tableware is not dry. No rinse aid used or dosage
set too low.
1. Add "Rinse aid" →Page27.
2. Set the amount of rinse aid to be
dispensed.
→"Setting the amount of rinse aid",
Page28
Programme or programme
option has no drying phase,
or the drying phase is too
brief.
▶
Select a programme with drying,
e.g. intensive, strong or ECO pro-
gramme.
Some option buttons decrease the
drying result, e.g varioSpeed.
To Next Page
Loading...
Need help?
General
