Troubleshooting aus
47
Fault Cause Troubleshooting
Remnants of food on table-
ware.
Tableware is placed too
close together or basket is
overfilled.
1. Arrange tableware with sufficient
space in between.
The spray jets must reach the sur-
faces of the tableware.
2. Avoid points of contact.
Spray arm rotation is
blocked.
▶
Arrange tableware so that it does
not obstruct spray arm rotation.
Spray arm nozzles are
blocked.
▶
Clean the "Spray arms" →Page42.
Filters are soiled.
▶
Clean the filters.
→"Cleaning filters", Page41
Filters are inserted incor-
rectly and/or not engaged.
1. Insert the filters properly.
→"Filter system", Page41
2. Engage the filters.
Washing programme selec-
ted too weak.
▶
Select a more intensive washing
programme.
▶
Adjust the sensitivity of the sensors.
→"Sensors", Page12
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
▶
Only remove large remnants of food
and do not prerinse tableware.
▶
Adjust the sensitivity of the sensors.
→"Sensors", Page12
Tall narrow receptacles in
corner areas are not rinsed
adequately.
▶
Do not position tall narrow recept-
acles at too great an angle or in
corner areas.
Top baskets on right and left
are not set to same height.
▶
Set the top baskets on the left and
right to the same level.
Detergent residue in the ap-
pliance
Lid of the detergent dis-
penser is blocked by items
of tableware parts and will
not open.
1. Arrange tableware in the top basket
tableware so the tab collecting tray
is not obstructed by tableware.
→"Arrange tableware", Page32
Items of tableware are blocking the
dispenser lid.
2. Do not place tableware or fra-
grance dispensers in the tablet col-
lecting tray.
The lid of the detergent dis-
penser is blocked by the tab
and will not open.
▶
Position the tab in the detergent dis-
penser crosswise, not vertically.
To Next Page
Loading...
Need help?
General
