Appliance settings en
43
10.Clean the inside of the detergent
drawer housing.
11.Push in the detergent drawer.
Q Appliance settings
Appliance setti ngs
You can change the following settings
in the control and display panel:
■ The volume of the information signal
(e.g. at the end of the programme),
■ The volume of the operating signals,
■ The brightness of the operating and
display field,
■ Select/deselect the memory function
for drum care.
You will need to activate the setting
mode in order to change these settings.
Activating the setting mode
1. Switch on the appliance. The
settings for the current programme
are displayed.
2. Touch the control panel œ.
The setting mode is activated and the
displays for the information signals U
and the preset volume light up.
You can now change the settings:
Changing the signal volume
To do this, touch N or M on the control
panel until the required adjustment
value for the volume of the information
signals appears:
Adjustment values:
Exit setting mode or:
Touch œ again. The display for the
operating signals C and the preset
volume light up.
Touch N or M to change the
adjustment value (as above).
Exit setting mode or:
0 off
1 quiet
2 Medium
3 loud
4 very loud
To Next Page
Loading...
Need help?
General
