en Water softening system/special salt
14
--------
+ Water softening
system / special salt
Wat er s of t eni ng sy st em/speci al sal t
To ensure good rinsing results, the
dishwasher requires soft water, i.e.
water which is low in lime, otherwise
limescale will be deposited on the
utensils and interior container. Tap
water above 7° dH (1.2 mmol/l) must
be softened. The water is softened with
special salt (regeneration salt) in the
water softening system
of the dishwasher. The setting and
therefore the required amount of salt
depends on the degree of hardness of
your tap water (see following water
hardness table).
Water hardness table
†– Tone volume *
†–:‹‹ - †–:‹„
†–:‹ƒ Volume of the signal.
›– Button volume *
›–:‹‹ - ›–:‹„
›–:‹ƒ Volume when using button.
§“ Factory setting ¢:“†
Confirm with +
Reset to the factory setting.
Setting up Factory setting Description
* depending on the configuration of your specific dishwasher
¯¯
¯³
¯
¯´
¯
¯
¯±
¯Å
:DWHU
KDUGQHVV
YDOXH
&ODUNH
VRIW
PHGLXP
KDUG
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
PPROO
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
6HWYDOXH
RQWKH
PDFKLQH
+DUGQHVV
UDQJH
KDUG
KDUG
PHGLXP
PHGLXP
VRIW
To Next Page
Loading...
Need help?
General
