en Operating the appliance
30
ExtraDry
The final rinse uses a higher
temperature which improves the drying
result (be careful if you have delicate
tableware). The running time may
increase slightly. You can switch the
function ExtraDry on š:‹‚ or off š:‹‹.
Auto Power Off
(Automatic switch off after
end of programme)
Au t o Power Of f
To save energy, the dishwasher is
switched off 1 minute after
the programme ends. You can also
change this setting.
Possible settings are:
■ ˜:‹‹: The dishwasher does not
switch off automatically.
■ ˜:‹‚: The dishwasher switches off
after 1 minute.
■ ˜:‹ƒ: The dishwasher switches off
after 2 hours.
Note: Note that with the settings ˜:‹‚
and ˜:‹ƒ the interior lighting 1" is
switched off. To activate the interior
lighting, press the ON/OFF switch (.
EmotionLight
(Interior lighting) *
Emot i onLi ght
* depending on the configuration of
your specific dishwasher
EmotionLight 1" is the interior lighting
for your dishwasher. You can switch the
interior lighting on “:‹‚ or off “:‹‹.
Notes
■ Depending on the setting of
AutoPowerOff, the interior lighting is
either switched on or off.
■ Note that when the appliance is
switched on and the door is open,
the interior lighting will automatically
be switched off after 1 hour.
Changing start programme
The Eco 50° programme for
environmentally friendly operation is
always preselected when the appliance
is switched on. You can change the
“Start programme” setting. With the
setting †˜:‹‹, the most recently
selected programme will always appear
when the appliance is switched on.
Tone volume
Whenever you switch the dishwasher on
or off, a signal sounds. You can adjust
the tone volume from †–:‹‹ - †–:‹„.
Button volume
When you are operating the dishwasher,
a signal sounds whenever a button is
pressed. You can adjust the volume of
the tone from ›–:‹‹ - ›–:‹„. If the
signal tone is annoying, set the value to
›–:‹‹ (button volume off).
Factory setting
You can reset all settings to the factory
setting.
To Next Page
Loading...
Need help?
General
