Fault, what to do? en
39
Food remnants on the
utensils.
Utensils placed too closely
together, utensils basket
overfilled.
Arrange utensils with adequate clearance
between them ensuring that the spray jets
can reach the surface of the utensils.
Prevent contact points.
Spray arm rotation obstructed. Arrange utensils so that the spray arm can
rotate without obstruction.
Spray arm nozzles are blocked. Clean the spray arm nozzles.
~ "Cleaning and maintenance"
on page 32
Filters 1Z dirty. Clean filters. ~ "Cleaning and
maintenance" on page 32
Filters 1Z inserted incorrectly
and/or not engaged.
Insert and engage filters correctly.
Wash programme too weak. Select a more intensive wash programme.
Increase sensitivity of the sensors.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Do not prerinse utensils. Remove only
large food remnants.
Increase sensitivity of the sensors.
Recommended programme Eco 50° or
Intensive.
Tall narrow receptacles in corner
areas are not rinsed adequately.
Do not place hollow receptacles too
obliquely and do not place in the corner
area.
Top basket 12 on right and left
not set to same height.
Set top basket to same height using side
levers.
Food remnants on the
dishes when pause
function is used. *
Dishes added too late. Only interrupt the rinse programme in the
initial phase to add more dishes.
Fault Reason Remedial action
*Depending on the features of your dishwasher
To Next Page
Loading...
Need help?
General
