8
Time program function
This function allows the selected hotplate to be switched off
automatically after a preset time by inserting the cooking time.
How to program
The hob should be switched on.
1.Select the required hotplate and power level.
Then press the
r symbol until the ‹‹ indicator is displayed.
The indicator lights up on the selected hotplate.
2.Set the time using the + or - symbols.
+ = 30 minutes
- = 10 minutes
After a few seconds, the timer will start to count down.
Once the time has elapsed
The hotplate turns off, there is a warning sound and the
‹
indicator lights up. Press the
r symbol. The indicators go out
and the sound stops.
To cancel or change the time
Select the hotplate with the
μ symbol. Press the r symbol
and change the cooking time with the + or -, symbols or set to
‹‹.
Note: Any cooking time can be programmed up to 99 minutes.
Default settings
The appliance has various default settings. These can be
adapted to the needs of the user.
Indicator Function
™‚
Automatic childproof lock
‹ Deactivated.*
‚ Activated.
™ƒ
Warning beeps
‹ Most beeps deactivated.
‚ Some beeps deactivated.
ƒ All beeps deactivated.*
™†
Automatic time limitation.
‹ Default setting: switch off after 1-10 hours.*
‚ The default setting is halved: switch off after 0.5 - 5 hours.
ƒ The default setting is quartered: switch off after 0.25 - 2.5 hours.
™‡
Duration of the time program function warning signal
‚ 10 seconds.*
ƒ 30 seconds.
„ 1 minute.
*Factory setting
To Next Page
Loading...
