Bosch PMD 10 - Working Advice; Mounting to a Wall; Fastening with Adhesive Tape Strips (see figure G); Fastening with Pins (see figure H)

English | 29
Bosch Power Tools 1 609 929 W57 | (14.7.10)
Working Advice
f Keep the adhesive tape strips 4 out of the reach of
small children. Children could mistake the strips
with chewing gum.
Mounting to a Wall
Four fastening methods are available for fastening the
wall holder to different surfaces:
– Fastening with Adhesive Tape Strips
(see figure G): With the removable adhesive tape
strips 4, the wall holder can be fastened to sensitive
or delicate sturctural materials without causing
damage to them. The structural surface must be
straight, firm, dry, grease-free and have a tempera-
ture of at least 15 °C . Pull off one of the protective
foils from an adhesive tape strip (c) and position
the adhesive tape strip onto the back side of the
wall holder (d) in such a manner that its end
projects out. Pull off the second protective foil (e)
and firmly press the wall holder with the adhesive
tape strip against the structural surface (f) for at
least five seconds. To remove the wall holder, pull
out the adhesive tape strip by the projecting end
slowly and as parallel as possible to the structural
surface (g).
– Fastening with Pins (see figure H): With the pins 2
provided, the wall holder can be fastened to drywall
or wooden walls. Insert the pins through the open-
ings in the wall holder as shown in the figure.
OBJ_BUCH-311-005.book Page 29 Wednesday, July 14, 2010 11:45 AM