Bosch PMD 7 User Manual

English | 17
Bosch Power Tools 2 609 140 996 | (23.9.13)
Declaration of Conformity
We declare under our sole responsibility that the product described un-
der “Technical Data” is in conformity with the following standards or
standardisation documents:
EN 61010-1:2010-10, EN 61326-1:2006-05,
EN 301489-3:2002-08, EN 301489-1:2011-09,
EN 300330-1:2010-02, EN 300330-2:2010-02 according to the provi-
sions of the directives 2011/65/EU, 1999/5/EC.
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 26.08.2013
Assembly
Inserting/Replacing the Batteries
Alkali-manganese batteries are recommended for the operation of the
measuring tool.
To open the battery lid 5, press on the latch 4 and fold the battery lid up.
Insert the batteries. When inserting, pay attention to the correct polarity
according to the representation on the inside of the battery compartment.
 If the measuring tool is not used for longer periods of time, remove
the batteries. The batteries can corrode or self-discharge after pro-
longed storage.
Operation
Initial Operation
 Protect the measuring tool against moisture and direct sun light.
 Do not subject the measuring tool to extreme temperatures or var-
iations in temperature. As an example, do not leave it in vehicles for
Henk Becker
Executive Vice President
Engineering
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
OBJ_BUCH-1913-002.book Page 17 Monday, September 23, 2013 12:33 PM

Bosch PMD 7 Specifications

General

Display type	-
Product color	Black, Green
Auto calibration	Yes
Built-in display	No
Detectable materials	Live cable, Non-ferrous metal
Maximum detection depth (steel)	70 mm
Maximum detection depth (copper)	60 mm
Maximum detection depth (live cable)	50 mm
Battery life	5 h
Battery type	AAA
Battery voltage	1.5 V
Battery technology	Alkaline
Auto power off after	10 min
Number of batteries supported	3
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	150 g