Bosch Power Charge 7000i - Page 12

Installation (only for approved contractors)
35
Power Charge 7000i – 6721849906 (2022/11)
▶ Screw the cable holder shield support using the screws.
Fig. 39 Cable holder installation
▶ Perform the internal interface connections.
Fig. 40 Optional internal interfaces connections
[1] Digital output (SW)
[2] Digital input (EN)
[3] Ethernet connection
▶ Place the parking holder at the front of the Power Charge
7000i using six screws.
Fig. 41 Parking holder installation
▶ Place the front cover of the Power Charge 7000i in the right
position and screw it using two screws.
Fig. 42 Front cover installation
0010044546-001
≤2,5 Nm
0010044548-001
0010044551-001
≤2 Nm
0010044590-001
≤1 Nm