52 | English
Main Menu
To access the main menu, press the left-hand function button(15).
Navigating in the menu
– To scroll through a menu: Press the up(17) or down(12) arrow buttons.
– To switch to a submenu: Press the red start button(16) or the right-hand arrow
button(7).
– To confirm a selected menu option: Press the red start button(16).
– To change a menu option using the on/off switch: Press either the red start
button(16), the left-hand(14) or the right-hand arrow button(7). This will also save
the menu option.
– To go back to the next highest menu: Press the left-hand function button(15) under
the back arrow.
– To leave the main menu and go back to measuring: Press the right-hand function
button(6) under the Home symbol.
Menu options
– <Measuring mode>
Set the required measuring mode(see "Overview of the measuring modes", page43).
Once you have made your selection, the measuring tool will directly switch to the se-
lected measuring mode.
In the<Object Detection> measuring mode, you can also set the wall type suitable
for the planned measurement and the view for the measurements.
– <Device Settings>
<Ruler>: Switch on/off the ruler for the measuring modes<Object Detection>
(with the exception of the<Spot View>) and for the<Leakage Detection>. Using
the ruler, you can determine the distance between object centres, for example.
Press the right-hand function button(6) to set the ruler to zero.
<Depth mode>: Choose between the indicator for the<Object depth> and the
maximum permissible<Drilling depth>.
<Display brightness>: Set the brightness level of the display backlight.
<Audio signals>: Switch the audio signal on or off. When the audio signal is
switched on, an audio signal sounds every time a button is pressed and every time
an object is found within the sensor range.
<Start-up settings>: Choose the settings (e.g. wall type, view, ruler) that the
measuring tool starts up when it is switched on. Choose between applying the set-
tings from the last time the tool was switched off and personalised basic settings
(these are the current settings in the main menu).
1 609 92A 5L5 | (11.01.2021) Bosch Power Tools
To Next Page
Loading...
