Bosch Professional Wallscanner D-tect 200 C - Starting Operation

English | 17
The lithium-ion battery can be charged at any time without reducing its service life. Inter-
rupting the charging process does not damage the battery.
The lithium-ion battery is protected against deep discharge by the "Electronic Cell Pro-
tection (ECP)". A protective circuit switches the measuring tool off when the battery is
drained.
To insert the charged battery pack(10), slide it into the battery bay(25) until you feel it
engage.
To remove the battery pack(10), press the release buttons (9) and pull the battery pack
out of the battery bay(25). Do not use force to do this.
Operation with non-rechargeable batteries (seefigureB)
It is recommended that you use alkaline manganese batteries to operate the measuring
tool.
The batteries are inserted into the battery adapter.
u The battery adapter is intended only for use in designated Bosch measuring
tools and must not be used with power tools.
To insert the batteries, slide the receptacle (28) of the battery adapter into the battery
bay(25). Place the batteries in the receptacle as shown in the picture on the cap(27).
Slide the cap over the receptacle until you feel it click into place.
To remove the batteries(26), press the release buttons(9) of the
cap(27) and pull off the cap. Make sure that the batteries do not fall
out by holding the measuring tool with the battery bay(25) facing up-
wards. Remove the batteries. To remove the receptacle(28) from in-
side the battery bay, reach into the receptacle and pull it out of the measuring tool, ap-
plying light pressure to the side wall as you do so.
Always replace all the batteries at the same time. Only use batteries from the same man-
ufacturer and which have the same capacity.
u Take the batteries out of the measuring tool when you are not using it for a pro-
longed period of time. The batteries can corrode and self-discharge during pro-
longed storage in the measuring tool.
Starting Operation
Switching on/off
u Before switching on the measuring tool, ensure that the sensor area(19) is dry.
If necessary, use a cloth to dry the measuring tool.
u If the measuring tool has been exposed to a significant change in temperature,
leave it to adjust to the ambient temperature before switching it on.
Bosch Power Tools 1 609 92A 5L6 | (29.12.2020)