Bosch PRS-1AIP1 - Default Settings; Configuration View

Bosch Security Systems | 2008-12
PRS-1AIP1 IP Audio Interface | Installation and User Instructions | Configuration en | 19
3.2.13 Default Settings
Default settings
Clicking Back to factory defaults button to restore the
factory defaults (except Network configuration). During
the restart a countdown screen will appear. Then the
successful loading of the factory defaults is confirmed.
Hard default settings
To revert all settings (including the Network
configuration) to factory defaults, the Reset button (1)
has to be pressed for about 5..10 seconds while the
device is powered.
3.3 Configuration view
When clicking CONFIG VIEW in the selection bar at
the top of the page, all configuration settings are shown,
including hardware and software version information of
the device:
• Device Information
• Version Information
• System Status
• Audio Status
• I/O Status
• Network Configuration
• Streaming Configuration
• Control Configuration
• Audio Configuration
• Supervision
• Serial Configuration
• SNMP Configuration
• Security Configuration
l
figure 3.14: Default settings screen
Caution
Your configuration parameters will be lost in
case the device is reset to factory default.
l
figure 3.15: Configuration View example screen