Bosch PRS-1AIP1 - 5 Connection Options; Unicast (Point to Point); Multiple Unicast; Broadcast

Bosch Security Systems | 2008-12
PRS-1AIP1 IP Audio Interface | Installation and User Instructions | Connection options en | 23
5 Connection options
This section illustrates how the IP Audio Interface can
be used. A data stream could be sent and receive by the
IP Audio Interface. Different methods could be defined
which depends on how the device is configured.
5.1 Unicast (point to point)
Unicast means: a single data stream to a single
predefined receiver device (Partner) in a LAN or WAN.
A typical partner IP address: 192.168.100.50
5.2 Multiple Unicast
Multiple Unicast means multiple data streams to
multiple receiver devices (Partners) in a LAN or WAN.
Typical partner IP addresses: 192.168.100.50,
192.168.100.51, 192.168.100.52, ...
5.3 Broadcast
Broadcast means: a single data stream to all receiver
devices (Partners) in a LAN. A typical partner IP
address: 192.168.100.255 configured in the transmitter
as Partner address. Then all partners with addresses
starting with 192.168.100 receive this stream. Typically,
routers in a WAN do not support Broadcast mode.
5.4 Multicast
Multicast means: predefined receiver devices (Partners)
each receive a single data stream in a LAN or WAN.
Typical partner IP addresses between: 224.0.0.1 to
239.255.255.255.
5.5 Re-broadcast
Re-broadcast means: a local device receives a data
stream from a remote device and resends it to other
devices (Partners) in a LAN or WAN.
l
figure 5.1: Unicast example (1=LAN/WAN)
l
figure 5.2: Multiple Unicast example (1=LAN/WAN)
1
X
1
l
figure 5.3: Broadcasting (1=LAN)
l
figure 5.4: Multicasting example (1=LAN/WAN)
l
figure 5.5: : Re-broadcasting (1=Internet, 2=Router,
3=LAN/WAN)
1
1
1
3
2 2