en Operating the appliance
28
3. Press the A button after approx. 10
minutes.The laundry will soak in the
water.
4. Leave the laundry to soak for as long
as required, then either press the A
button again to resume the program
or change the program.
Note: No additional detergent is
required as the water used for
soaking will be reused for washing.
Rinse hold
$
If final spinning is not selected, the
laundry will remain in the water after the
final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
To resume/end the programme
~ Page 31
i-DOS
ý i-DOS w/þ i-DOS M/w
Your appliance has an intelligent dosing
system for liquid detergent (w) and
fabric softener (M).
The optimum quantities of liquid
detergent and fabric softener are
dispensed automatically.
You can press ý i-DOS w/þ i-
DOS M/w to activate or deactivate
automatic dosing and set the basic
dosages.
~ "Intelligent dosing system"
on page 38
1 Operating the
appliance
Operati ng the appliance
Preparing the washing
machine
Note: The washing machine must be
correctly installed and connected.
From ~ Page 13
1. Connect the mains plug.
2. Turn on the water tap.
3. Open the door.
4. Check that the drum is completely
drained. Drain if necessary.
Switching on the appliance/
selecting a programme
Press the # button. The appliance is
switched on.
The Cottons programme set at the
factory is then always displayed.
The current settings and programme
information light up at full brightness
and the display A flashes.
The settings that can be selected light
up at half brightness.
Notes
■ Temporary flashing of the displayÛ
informs you to run the programme
Drum Clean or any other
programme soon at a washing
temperature of at least 60 °C.
■ If the E 3s display flashes, the
childproof lock is active.
You must deactivate this first before
you can change settings or start the
programme. ~ Page 30
To Next Page
Loading...
Need help?
General
