en Intelligent dosing system
40
detergent/care product you are using,
the water hardness and/or the degree
of soiling.
Adjusting the basic dosage
1. Press and hold ý i-DOS w and/or
þ i-DOS M/w for approx. 3
seconds.
The basic dosage setting will be
displayed.
2. Change the setting using: ˜/~
3. To exit setting mode, press and hold
ý i-DOS w and/or þ i-DOS M/w
for approx. 3 seconds or wait
approx. 10 seconds.
Notes
■ The changes are applied to all
programmes in which dosing is
possible.
■ The changes are saved until the next
time they are changed and are
retained even after the appliance has
been switched off.
Filling the dispensers
Notes
■ See the instructions in chapter
~ "Before setting up i-DOS"
on page 38
■ If w or M flashes, fill the relevant
dispenser. ~ Page 38
Fill the dispensers as follows:
1. Pull out the detergent drawer.
2. Open the dispenser lids.
3. Pour liquid detergent and fabric
softener into the relevant dispensers.
Notes
– Do not fill the dispensers above
the max. mark.
– Follow the instructions in
chapters ~ "i-DOS Setting the
dosage" on page 39 and ~ "i-
DOSSetting the content of the
M/w dispenser" on page 39.
4. Close the dispenser lids.
Note: To prevent the detergent
drying out or drying up, do not leave
the dispenser lids open for a long
period of time.
5. Push in the detergent drawer.
To Next Page
Loading...
Need help?
General
