To Next PageTo Next Page
Need help?Do you have a question about the Bosch Rexroth A10VG45 and is the answer not in the manual?
General| Displacement | 45 cm³/rev |
|---|---|
| Nominal Pressure | 280 bar |
| Maximum Pressure | 350 bar |
| Open circuit | Yes |
| Shaft Type | Spline shaft |
| Port Connection | SAE |
Provides fundamental safety guidelines for operating variable pumps and their safe handling.
Defines the qualifications and knowledge required for personnel working with the manual.
Explains how to identify the variable pump using its name plate and its details.
Provides a general overview of the functionality and design of the A10VG variable pump.
Specifies where to find the technical data for the variable pump, referencing data sheets.
Details the step-by-step procedure for replacing the shaft seal on the variable pump.
Covers the replacement of various seals for components like covers, valves, and auxiliary pumps.
Provides instructions for replacing the auxiliary pump and its associated o-ring.
Explains the procedure for replacing the control unit or its o-ring on the variable pump.
Describes how to connect a manometer and check the low pressure (charge pressure) of the pump.
Explains how to check the high pressure, noting it refers to the pressure cut-off value.
Details the procedure for checking the mechanical zero stroke for different controller types.
Describes how to check the hydraulic zero stroke for HW, HD, and EP controllers.
