Need help?Do you have a question about the Bosch REXROTH A4VSO and is the answer not in the manual?
General| Fluid | Hydraulic Oil |
|---|---|
| Circuit Type | Open Circuit |
| Type | Axial piston pump |
| Maximum Pressure | 350 bar |
| Weight | Varies by model |
| Fluid Compatibility | Mineral oil, synthetic esters |
| Displacement Range | 28 to 500 cm³/rev |
Provides general guidelines for safe handling, operation, and maintenance of the product.
Highlights specific dangers and safety measures related to the axial piston unit and HS5E control.
Warns against improper handling that can lead to product damage or personal injury.
Details risks associated with insufficient hydraulic fluid and improper lubrication.
Advises against mixing different hydraulic fluids to prevent product damage.
Highlights the importance of fluid cleanliness to prevent wear and malfunctions.
Specifies limits and warnings related to maximum working pressures and fluid jets.
Provides general instructions and specific procedures for installing the axial piston unit.
Guides on connecting hydraulic lines, emphasizing suction pressure and line routing.
Details electrical connection requirements, including warnings about short circuits.
Outlines the initial steps and precautions for commissioning the axial piston unit.
Provides procedures for filling and air bleeding the axial piston unit with hydraulic fluid.
Describes the process of performing a functional test after hydraulic supply is confirmed.
Details how to establish a connection between the HS5E system and the IndraWorks software.
Guides on configuring basic settings for the HS5E control system using IndraWorks.
Details how to set controller parameters for optimal system performance.
Explains the process of calibrating the HS5E control system for consistent behavior.
Guides on systematic troubleshooting steps and gathering information about faults.
Provides a table listing malfunctions, possible causes, and remedies for axial piston units.
To Next Page