Bosch Rexroth A7VO 63 Series - Ordering Code

Bosch Rexroth AG, RE 92202/02.2015
2 A7VO Series 63 | Axial piston variable pump
Ordering code
Ordering code
01 02 03 04 05 06 07 08 09 10 11 12 13
A7V O / 63 – V B 01
Axial piston unit
01 Bent-axis design, variable, nominal pressure 350 bar, maximum pressure 400 bar
A7V
Operating mode
02 Pump, open circuit
O
Size (NG)
03
Geometric displacement V
g
(cm
3
), see “Technical data” on page 7
28 55 80 107 160
For sizes 250, 355 and 500, see data sheet 92203
Control device 28 55 80 107 160
04 Power controller without power override ● ● ● ● ●
LR
with pressure cut-off ● ● ● ● ●
LRD
with stroke limiter negative control
Δp = 25 bar
– ● ● ● ●
LRH
with pressure cut-off and stroke limiter negative control
Δp = 25 bar
– ● ● ● ●
LRDH1
with pressure cut-off and load sensing – ● ● ● ● LRDS
Power controller with hydraulically proportional power override
(only available for clockwise rotation and with port plate 02)
with load sensing – ● ● – – LA1S
with load sensing and hydraulically proportional LS-override – ● ● – – LA1S5
Pressure controller ● ● ● ● ●
DR
remotely controlled ● ● ● ● ●
DRG
with load sensing – ● ● ● ●
DRS
Proportional control hydraulic Positive control
Δp = 10 bar
● ● ● ● ●
HD1
with pressure cut-off, remotely controlled Positive control
Δp = 10 bar
● ● ● ● ●
HD1G
Proportional control electrical
Positive control
U = 24 V
● ● ● ● ● EP2
Series
05 Series 6, index 3
63
Direction of rotation
28 to 160
06 Viewed on drive shaft clockwise ●
R
counter-clockwise ●
L
Sealing material
07 FKM (fluoroelastomer)
V
Drive shaft
28 to 160
08 Splined shaft DIN 5480 ●
Z
Parallel keyed shaft according to DIN 6885 ●
P
Mounting flange
09 ISO 3019-2; 4-hole
B
Port plate for working lines
10 SAE flange ports A and S at rear (metric fastening thread)
01
SAE flange ports A and S at side (available for power controllers LA1S and LA1S5 only, metric fastening thread)
02
● = Available – = Not available = Preferred program