Electric Drives
and Controls
1−11Bosch Rexroth AGBT 6.1901070087068 / 01
Safety Instructions
1.10 Working Safely
DANGER
If the start signal is present on fault reset (acknowledge), the weld
timer immediately starts the program sequence! Hazardous ma-
chine movements may be the result!
Therefore, before fault reset, you should make sure that there are
no persons in the danger zone of the welding equipment!
DANGER
During operation of the welding equipment welding splashes are
to be expected! They may cause eye injuries or burns. Therefore:
− wear protective goggles
− wear protective gloves
− wear flame-retardant clothes
DANGER
Danger of injury from sheet metal edges and danger of burns from
weld metal!
Therefore: − wear protective gloves
CAUTION
The strong magnetic fields occurring in the resistance welding
process may cause permanent damage to wrist watches, pocket
watches, or cards with magnetic stripes (e.g. EC cards).
Therefore, you should not carry any such items on you when wor-
king in the immediate vicinity of the welding equipment.
To Next Page
Loading...
Need help?
General
