Bosch Security Systems User Manual

42
WALK TEST ?WALK TEST ?
WALK TEST ?WALK TEST ?
WALK TEST ?
continuedcontinued
continuedcontinued
continued
4. The burglary bell sounds for 2 seconds. When
the display panel shows
## PTS TO TEST## PTS TO TEST
## PTS TO TEST## PTS TO TEST
## PTS TO TEST you
can begin. Test each point by first opening and
then closing the door or window. Check the
display after testing each point. For interior
points, walking past the device once is
sufficient. If any point does not test correctly,
contact the security company for service.
5. During the Walk Test you may want to see the
points that remain untested. When point text is
displayed, press
ESCESC
ESCESC
ESC. The display shows
## PTS## PTS
## PTS## PTS
## PTS
TO TESTTO TEST
TO TESTTO TEST
TO TEST. Press the
ESCESC
ESCESC
ESC key.
VIEW UNTESTED VIEW UNTESTED
VIEW UNTESTED VIEW UNTESTED
VIEW UNTESTED
??
??
? is displayed. Press
ENTENT
ENTENT
ENT. The display shows
## PTS UNTESTED## PTS UNTESTED
## PTS UNTESTED## PTS UNTESTED
## PTS UNTESTED. Press
NEXTNEXT
NEXTNEXT
NEXT to see a list
of the points that are untested. Move through
this list by pressing the
NEXTNEXT
NEXTNEXT
NEXT key. To resume
the Walk Test, press
ESCESC
ESCESC
ESC.
# PTS UNTESTED # PTS UNTESTED
# PTS UNTESTED # PTS UNTESTED
# PTS UNTESTED
is displayed. Press
ESCESC
ESCESC
ESC.
## PTS TO TEST ## PTS TO TEST
## PTS TO TEST ## PTS TO TEST
## PTS TO TEST is
displayed. Resume testing points. To end the
Walk Test, press
ESCESC
ESCESC
ESC twice.
6. When all points are tested,
0 PTS TO TEST 0 PTS TO TEST
0 PTS TO TEST 0 PTS TO TEST
0 PTS TO TEST is
displayed. Press
ESCESC
ESCESC
ESC. The display momentarily
shows
ALL PTS TESTEDALL PTS TESTED
ALL PTS TESTEDALL PTS TESTED
ALL PTS TESTED before returning to
idle text.

Bosch Security Systems Specifications

General

Brand	Bosch
Model	Security Systems
Category	Security System
Language	English