19
B O S C H
* Model dependent
ENglISH
The iron does not
heat up.
minimum.
2. The “SensorSecure” system has been
activated. The iron is set to stand-by.
1. Turn to a higher position.
2. Grip the handle of the iron to re-start
it.
The “TempOK”
lights inside the
temperature
cooling down to the selected
temperature.
1. This is normal and lights will stop
temperature is reached.
The clothes tend
to stick
1. The temperature is too high.
down and wait until the iron has
cooled down.
Water drips out of
together with
steam.
low.
3. You have pressed the shot of steam
for 5 seconds between each press.
higher setting and wait until the
“TempOK” lights inside the
remain lit continuously.
setting.
3. Wait 5 seconds between each press
of the shot of steam button.
Steam does not
come out.
position.
2. The temperature is too low. Anti-drip
system is activated.
1. Set the steam regulator to a higher
position.
2. Set to a higher temperature if
compatible with the fabric.
Smoke comes out
when connecting
time.
1. This may be caused by the lubrication
of some of the internal parts.
1. This is normal and will stop after a
few minutes.
Excessive dripping
or steaming.
1. No proper closing of “Calc’nClean”
system.
1. Actuate a few times the “clean”
Deposits come out
through the holes
in the soleplate
1. Traces of lime scale are coming out of
the steam chamber.
1. Carry out a cleaning cycle
If none of the above solves the problem, get in touch with an authorised technical service.
To Next Page
Loading...
