15
B O S C H
* Model dependent
AntiCalc
Multiple descaling system
B. Calc'nClean
A. self-clean
D. anti-calc
C.
A self-clean
Each time you use the steam regulator (3),
the “self-clean” system cleans the
mechanism of scale deposits.
B Calc’nClean
The “Calc’nClean” function helps to remove
scale particles out of the steam chamber.
Use this function approximately every 2
weeks if the water in your area is very hard.
1 Unplug the iron from the mains socket,
set the steam regulator (3) to the
position and ll the water tank (11) with
water.
45º
2 Set the temperature control (12) to the
“max” position and plug in the iron.
3 After the necessary warm-up period, the
“TempOK” lights inside the temperature
control (12) stop ashing. Then, unplug
the iron (very important!).
4 Set steam regulator to the “max”
position.
To Next Page
Loading...
