Not all terminals are used. To protect power modules, two
plugs are used to cover unused terminals.
5.3 Dispensers
Although many dispenser components can be replaced, it’s
quicker to replace the entire dispenser.
5.3.1 To remove dispensers
Tools needed: T20 Torx & flat blade screwdrivers.
1. Remove outer door – section 5.1.2.1.
2. Disconnect wire harnesses from dispenser after noting
connector locations (below left).
3. Remove cable guide (below right).
m CAUTION – 80% of all controls returned
for analysis check out OK. Most control
issues are due to loose connections.
4. Carefully pry inner door flanges (1) away from the tabs (2)
on the top and bottom of the dispenser (see below).
1
2
702_58300000130262_ara_en_c Page 27 of 50
To Next Page
Loading...
