Bosch SHE4AM12U - 3.5 Special programs (codings)

3.5 Special programs (codings)
Controls can run customer service tests, show error codes, run
sales demo programs and run factory tests. The same procedure
is used to access all programs – don’t run factory tests.
All programs are listed for questions about unknown codes or
displays occasionally encountered on dishwashers.
3.5.1 SHE “Evolution” models
To enter Special programs, press and hold “>” and Delay
buttons, then turn dishwasher on. When Special programs are
accessed, left program light will flash and 2
nd
program light from
left will be lit (see below). For models with digital displays, the
display will show “P0”.
 To scroll through programs, press “<” button.
 To start programs shown with “*”, press “>” button.
 To exit Special programs, turn dishwasher off
 Programs shown with “+” are started with the Start button
(don’t run these programs).
 Run only programs shown in bold type (error codes,
customer service & sales demo).
3.5.2 SHX “Integra” models
To enter Special programs, press and hold “<” and “>”buttons,
then turn dishwasher on. When Special programs are accessed,
Regular Wash light will flash and Quick Wash light will be lit
(see below).
SHE LED
displays
SHE Special programs
Error codes* / Functional test+
Customer service test*
High voltage test*
Endurance run+
UL program*
Showroom (sales demo)*
SHE digital
display
P0
P1
SHX basic settings
Extra Dry (off
)
P2
P3
P6
P7
SHX Special programs
Error codes* / Functional test+
Customer service test*
High voltage test*
Endurance run+
UL program*
Showroom (sales demo)*
SHX LED
displays
Power
Scrub
Regula
r
Quick
Extra Dry (
on
)
Rinse Aid (none
)
Rinse Aid (low
)
Rinse Aid (medium
)
Rinse Aid (high
)
Tone Volume (off
)
Tone Volume (low
)
Tone Volume (medium
)
Tone Volume (high
)
SHX LED
displays
Power
Scrub
Regular Quick
702_58300000130262_ara_en_c Page 8 of 50