EasyManua.ls Logo

Bosch SHP9PCM5N - Basic Settings; Overview of Basic Settings; Changing Basic Settings

Bosch SHP9PCM5N
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Basic settings en-us
23
Basic settings
14 Basic settings
Basic settings
You can configure the basic settings for your appliance to meet your needs.
14.1 Overview of the basic settings
The basic settings depend on the features of your appliance.
Basic setting Display text Selection Description
W. hardness H:00
1
H:00 - H:07 Set the water softening system to your water
hardness.
→
"Setting the water softening system",
Page15
Level H:00 switches the water softening
system off.
Rinse aid disp. r:05 
1
r:00 - r:06 Set the amount of rinse aid.
→
"Setting the amount of rinse aid", Page17
Switch the rinse aid system off with level
r:00.
Sensor setting SE:00
1
SE:00 - SE:02 Set the water sensor for identifying soiling.
→
"Sensors", Page6
Extra Dry d:00
1
d:00 - d:01 The temperature is increased during the final
rinse, which improves the drying result. This
may increase the run time slightly.
Note:Not suitable for delicate items of
dishware.
Switch Extra Dry on "d:01" or off "d:00".
EmotionLight EL:02
1
EL:00 - EL:02 Interior lighting.
¡ With the setting "EL:00", the interior
lighting is switched off.
¡ With the setting "EL:01", the interior
lighting can be activated via the ON/OFF
button.
¡ With the setting "EL:02", the interior
lighting goes on when you open the
appliance door.
When the appliance door is opened, the
interior lighting switches off automatically
after 10 minutes.
Start cycle SP:00
1
SP:00 - SP:01 Set a default cycle for when the appliance is
switched on.
¡ With the setting "SP:00", the last cycle
selected and the last additional function
selected are set by default when the
appliance is switched on.
¡ With the setting "SP:01", the standard
cycle is set by default when the appliance
is switched on.
Signal volume SL:02
1
SL:00 -SL:03 Adjusting the signal volume.
Level "SL:00" switches the signal tone off.
Button volume bL:02
1
bL:00 - bL:03 Set the button volume during operation.
Level "bL:00" switches the button tones off.
1
Factory setting (may vary according to model)

Table of Contents

Related product manuals