Home Connect NL
Basic setting
Remote Start
Display text
rc11
Choise
rc0 - rc2
Description
"Remote Start", page 38
activate or deactivate.
The following settings are possible: †
With the setting "rc0", the function
permanently deactivated. †With
the setting "rc1", the func-
tie can be selected via the button
†
"Activating Remote Start",
page 39
†With the setting "rc2", the function
permanently activated.
Factory setting re Start with
YES
Confirm
of
Reset changed settings to
factory condition.
Initial commissioning
settings must be specified.
1
Factory setting (may differ depending on the device type)
Change basic settings
huhhuh
uncle Connect
uncle Connect
1.Press.
huhd
uncleConnect
2.Approx. 3 seconds on
to access the basic settings.
Busy-
this device is network capable.
Connect your appliance to a mobile
terminal device to be able to operate
functions via the Home Connect app.
The Home Connect services are not
available in every country. The
availability of the Home Connect
function depends on the availability of
the Home Connect services in your
country. Information on this can be
found at: www.home-connect.com. In
order to use Home Connect, you must
first establish a connection to the
WLAN home network (Wi-Fi1) and can
be configured with the Home Connect
app.
†→
†Device with WLAN home network
connect work (wifi)", page 38
aThe display shows Hxx. aThe
display shows reflected
to give.
3.Just as often on
until the display shows the desired
setting.
to press
4.Just as often on
the display shows the desired
value.
press until
You can change multiple settings.
5.To save the settings, press . for
about 3 seconds to press.
1Wi-Fi is a registered trademark of the Wi-Fi Alliance.
37
To Next Page
Loading...
