deRinse aid system
Only use up to a water hardness of
21 °dH without adding special salt.
¡The water hardness level is 0 -
6 °dH. You can do without special
salt.
Additional runtime in
minutes
7
Additional water consumption
in liters
5
Additional consumption of electricity
in kWh
0.05
1. press.
2.To open the basic settings,
3 seconds
press.
The consumption values given are
laboratory measurements according
to the currently applicable standard
and determined using the Eco 50°
program and the factory-set water
hardness value of 13 - 16 °dH.
aThe display shows Hxx. a
The display shows .
3. Press repeatedly until the
display shows H00.
4.To save the settings,
Press for 3 seconds.
11 Rinse aid system
aThe softening system is equipped
switches on and the salt refill
indicator is deactivated.
11.1 Rinse aid
10.5 Regenerate the softening
system
For best drying results, use rinse aid.
Use only household dishwasher
rinse aid.
In order to maintain the trouble-free
function of the softening system, the
device regenerates the softening
system at regular intervals.
In all programs, the water softener is
regenerated before the end of the
main wash cycle. The running time
and the consumption values increase,
e.g. B. Water and electricity.
Fill in rinse aid
When the rinse aid refill indicator
lights up, refill rinse aid. Use only
household dishwasher rinse aid.
1.The tab on the lid of the rinse aid
reservoir
press and lift.
Overview of the consumption values
when regenerating the
Softening system
2
Here you will find an overview of the
maximum additional running time and
consumption values when regenerating
the softening system.
Regenerate the ent
system according to x
corridors
hard-
dishwashing
6
1
28
To Next Page
Loading...
