Need help?Do you have a question about the Bosch Solution-16 and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | Solution-16 |
| Category | Control Panel |
| Language | English |
Welcome message and purpose of the quick reference guide.
Overview of system programming and available methods.
Detailed steps to program the system using a codepad.
Explanation of codepad indicator states for different data values.
How to program various options by combining bits.
Illustrates combining option bits for programming.
List of commands available in installer programming mode.
Procedures for arming the system in AWAY and STAY modes.
Procedures for disarming the system in AWAY and STAY modes.
Steps for standard zone isolation.
Steps to isolate zones using a user code.
Steps to enter and perform a walk test of the system.
Steps to add, delete, or change user codes.
Steps to configure the system's date and time.
How to display and interpret fault conditions.
Performing tests on speakers, bells, and strobes.
Initiating a modem call for alarm link communication.
Explanation of authority levels for user codes.
Explanation of auxiliary codes and their assigned levels.
List and description of various zone types.
List and description of available zone options.
Explanation of three-digit event codes for reporting.
Settings for codepad duress, panic, and access denial.
Settings for AC fail, low battery, and program altered code reporting.
Settings for sensor watch for different versions.
Settings for area open and close reports.
Configuration of system outputs and their functions.
List of event codes associated with output types.
Explanation of different output polarity modes.
Options for setting the time base and multiplier.
Description of the one shot mode for output operations.
Setting the system's entry and exit time delays.
Setting the system's date and time.
Settings for auto-arming and pre-alert times.
Configuration for siren run time and sound rate.
Setting swinger shutdown counts for siren and dialler.
Configuration settings for dialler options.
Various system configuration options.
Options for the DTMF command module.
Options for handling telephone line failures.
Settings for area open and close reports.
Assigning zones to codepads for specific areas.
Assigning user codes to specific operational areas.
Configuration for RF/Telco failures and RF jamming.
Setting the dialler lockout count for version 1.40+.
Settings for RF supervision, reporting, and jamming delay.
Configuration of system options, carrier sync, and defaults.
Setting the system time.
Wiring connections for split EOL resistors.
Description of Safecom interface board connections.
To Next Page