• Not Used — Assign this to zones that you do not intend to use, so that they
are removed from the system.
Each zone has a unique location that specifies its zone type. In order to select one of
the above zone types for a specific zone, you will need to enter its corresponding
number into the zone type location for that zone:
• 0 = Instant
• 1 = Handover
• 2 = Delay-1
• 9 = 24hr Tamper
• 15 = Not Used
These are the locations for the zone types for all zones (including default zone types):
• Zone 1 = 267 (default = 2 — Delay-1)
• Zone 2 = 274 (default = 1 — Handover)
• Zone 3 = 281 (default = 1 — Handover)
• Zone 4 = 288 (default = 1 — Handover)
• Zone 5 = 295 (default = 0 — Instant)
• Zone 6 = 302 (default = 0 — Instant)
• Zone 7 = 309 (default = 0 — Instant)
• Zone 8 = 316 (default = 9 — 24-Hour Tamper)
• Zone 9 = 323 (default = 15 — Not Used)
• Zone 10 = 330 (default = 15 — Not Used)
• Zone 11 = 337 (default = 15 — Not Used)
• Zone 12 = 344 (default = 15 — Not Used)
• Zone 13 = 351 (default = 15 — Not Used)
• Zone 14 = 358 (default = 15 — Not Used)
• Zone 15 = 365 (default = 15 — Not Used)
• Zone 16 = 372 (default = 15 — Not Used)
The following example will show you how to set up a standard system with Zone 1 as an
entry delay, Zone 2 as a “handover”, Zone 3 as an “instant”, Zones 4 - 8 as “not used”,
and Zone 16 as your tampers (Solution 3000):
1. Enter the text menu: [ 1 2 3 4 # ]
2. Enter address program: [ 8 1 ]
3. By default, Zone 1 is already set as Delay-1, so we can leave it.
4. By default, Zone 2 is already set as a Handover, so we can leave it.
Page !4 of !12
To Next Page
Loading...
Need help?
General
