5. Go to the location of the zone type for Zone 3: [ 2 8 1 # ]
6. Change the 1 (Handover) to a 0 (Instant): [ 0 * ]
7. Go to the location of the zone type for Zone 4: [ 2 8 8 # ]
8. Change the 1 (Handover) to a 15 (Not Used): [ 1 5 * ]
9. Go to the location of the zone type for Zone 5: [ 2 9 5 # ]
10. Change the 0 (Instant) to a 15 (Not Used): [ 1 5 * ]
11. Go to the location of the zone type for Zone 6: [ 3 0 2 # ]
12. Change the 0 (Instant) to a 15 (Not Used): [ 1 5 * ]
13. Go to the location of the zone type for Zone 7: [ 3 0 9 # ]
14. Change the 0 (Instant) to a 15 (Not Used): [ 1 5 * ]
15. Go to the location of the zone type for Zone 8: [ 3 1 6 # ]
16. Change the 9 (24-Hour Tamper) to a 15 (Not Used): [ 1 5 * ]
17. Zones 9 - 15 are set as “Not Used” by default, so can be left as they are.
18. Go to the location of the zone type for Zone 16: [ 3 7 2 # ]
19. Change the 15 (Not Used) to either a 9 or 0: [ 9 * ] or [ 0 * ]
20. Save and exit programming mode: [ 9 6 0 # ]
To further elaborate, using Zone 3 as an example:
1. We went to the location of the zone type for Zone 3: [ 2 8 1 # ]. The number 1 was in
that location, indicating that the zone type for Zone 3 was a handover.
2. We changed the 1 (Handover) to a 0 (Instant): [ 0 * ]
Using the above information, make the necessary programming changes to your system. If
you are using a Solution 2000, only zones 1 - 8 can be used, so you should use Zone 8 as
your tamper zone, which is already a 24-hour tamper by default.
III. Handover Delay Sequential
If you have zones with a handover zone type, those handover zones must be triggered
in order (i.e., Zone 2, Zone 3, etc.) following a delay zone in order to carry on its entry
time, otherwise an alarm will activate. If you require a system with handover zones that
may be triggered out of order following a delay zone (e.g., Zone 3, Zone 2), then you
may choose handover delay to be non-sequential:
1. Enter programming mode: [ 1 2 3 4 # ]
2. Go to the location for System Options 3: [ 4 9 4 # ]
3. Change the 8 to a 0: [ 0 * ]
4. Save and exit: [ 9 6 0 # ]
Options
Page !5 of !12
To Next Page
Loading...
Need help?
General
