EasyManua.ls Logo

Bosch T4200 18-2D - Key to Symbols and Safety Instructions; General Safety Information

Bosch T4200 18-2D
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Key to symbols and safety instructions
Therm 4200 – 6 720 821 605 (2017/08)
1 Key to symbols and safety instructions
1.1 Key to symbols
Warnings
Warnings in this document are identified by
a warning triangle printed against a grey
background.
Keywords at the start of a warning indicate
the type and seriousness of the ensuing risk
if measures to prevent the risk are not taken.
The following keywords are defined and can be used in this
do
cument:
NOTICE indicates a s
ituation that could result in damage to
property or equipment.
CAUT
ION indicates a situation that could result in minor to
medium injury.
WARNI
NG indicates a situation that could result in severe
injury or death.
DA
NGER indicates a situation that will result in severe
injury or death.
Important information
This symbol indicates important information
where there is no risk to people or property.
Additional symbols
Table 1
Symbol Explanation
Step in an action sequence
Cross-reference to another part of the document
List entry
List entry (second level)
1.2 Safety information
Important
Read these instructions for use
carefully so as to familiarize yourself
with the appliance before connecting
it to its gas container.
Keep these instructions for future
reference.
If there is a smell of gas:
Close the gas valve.
Open windows.
Do not connect any electrical
appliance.
Extinguish any naked flames.
Phone the gas company or an
authorized technician from a safe
distance.
If there is a smell of burnt gases:
Disconnect the appliance.
Open doors and windows.
Inform an installation company.
Fitting, modifications
The fitting and modification of the
installation of the appliance must be
carried out only by an authorized
technician.
The installation of the water heater
may only be carried out by a
registered installer and that such
installations shall comply with the
requirements of SANS 10087-1.
The pipes carrying burnt gases must
not be modified.
Do not close or reduce air circulation
holes.

Related product manuals