To Next PageTo Next Page
Need help?Do you have a question about the Bosch Therm 8000 S and is the answer not in the manual?
General| Type | Tankless |
|---|---|
| Fuel type | Natural Gas or Propane |
| Control system | Electronic |
| Voltage | 120V |
| Heat Exchanger Material | Copper |
| Temperature Range | 100°F to 140°F |
| Venting | Direct Vent |
| Power | 120W |
| Frequency | 60 Hz |
| Material | Stainless Steel |
| Hot water production | Continuous |
| Gas Connection | 3/4 inch |
| Water Connection | 3/4 inch |
| Capacity | Tankless |
| Safety Features | Overheat Protection |
| Efficiency | Up to 98% |
Explanation of symbols used in the manual for clear understanding.
Essential safety instructions for operation, hazards, and precautions.
Statement of compliance with relevant European directives.
Guide to understanding the product's model designation.
List of items included in the product packaging.
Overview of the appliance's design and main features.
Information on available additional components for the unit.
Detailed measurements of the appliance for installation planning.
Identification of key components and parts of the appliance.
Schematic representation of the electrical connections and layout.
Key performance specifications, technical values, and ratings.
Introduction to the appliance's operating procedures.
Explanation of the appliance's control panel display.
Essential checks and warnings before starting the appliance.
Steps for powering the appliance on and off.
How to adjust the hot water output temperature.
Guidance on the normal functioning and use of the appliance.
Procedure for pairing the optional remote control unit.
Instructions for using the optional remote control.
How to program and save temperature settings.
Managing user priority for temperature settings.
Procedure to remove air and prevent freezing.
How to clear errors and reset the appliance.
Understanding and resolving the 'locked' appliance status.
Crucial considerations and advice before commencing installation.
Guidelines for choosing the optimal installation site.
Required clearances around the appliance for safety and access.
Steps for mounting the appliance's support bracket.
Step-by-step guide for physically installing the unit.
Instructions for connecting the hot and cold water pipes.
Guidance on connecting the condensate water drain.
Critical steps for safely connecting the gas supply.
Installing flue accessories for exhaust and air intake.
Procedure for filling the condensate trap before operation.
Details on flue and air intake accessories by diameter size.
Guidelines for the correct installation of flue accessories.
Explanation of symbols used in accessory installation diagrams.
Information on valid configurations for exhaust systems.
Requirements for safe and compliant electrical hook-up.
Details regarding the appliance's power cord and plug.
Understanding factory-sealed parts and initial configurations.
Procedure for checking and setting gas inlet pressure.
How to fine-tune combustion by adjusting CO2 levels.
Description of adjustable program values and their effects.
Accessing and interpreting error codes and operational data.
Optimizing fan speed based on flue system length.
Routine checks, inspections, and servicing schedule.
Procedure for checking and verifying fuses in the control unit.
Inspection and cleaning of the heat exchanger unit.
Steps required to safely restart the appliance post-service.
Detailed list of display errors, causes, and solutions.
