6 720 680 174 (2014/05)Therm 8000S
Admission / exhaustion accessories (accessory Ø 80/125 mm) | 23
6.2 Fitting instructions
• The permissible maximum flue/air pipe length, Lmax, for the
various possible flue configurations is specified in the tables
starting on chapter 8.6.
• If the concentric flue/air pipe enters a chimney below
ground level, the appliance may register a fault and shut
down in cold weather due to ice formation. For that reason
such flue configurations should be avoided.
6.3 Explanation of Symbols on Fitting Diagrams
▶ Lightly grease seal on flue side with solvent-free
grease (e.g. Vaseline) (Fig. 35).
▶ Push flue kit fully home (in this case: 50 mm
insertion depth) (Fig. 36).
▶ Drill two 3-mm diameter holes in the
combustion air pipe. Maximum drilling depth 8
mm. It is essential that flue pipe is not damaged!
Fig. 37).
▶ Secure joint with the screws supplied (Fig. 38).
Fig. 35
Fig. 36
Fig. 37
Fig. 38
To Next Page
Loading...
