6 720 680 174 (2014/05) Therm 8000S
12 | Operating instructions
▶ Test the remote control in front of the electronic box by
simultaneously pressing the and control keys.
Fig. 15 Activate new control
▶ Press both keys until the LCD panel stops flashing and
shows the indication “00”.
▶ Press ON/OFF button(Fig. 4 , [1]) to disconnect the
appliance .
Remote control is now deactivated.
4.7 Remote control operation (accessory nº 7 709
003 756)
This appliance fulfils European directive requirements 1999/
5/CEE (R&TTE) and corresponds to the specifications
described in the cor-responding CE certificate of proof.
▶ Press buttons and in order to reach requested
temperature.
Fig. 16 Remote control (temperature selection)
Batteries replacement
▶ Remove the 2 screw from the remote control back.
▶Open the cover.
▶ Remove the old batteries and correctly place the new ones.
▶ Close the remote control assuring that both screws are
tighten screwed.
Precautions when using the batteries
• Do not dispose of batteries as domestic waste. Take them to
appropriate collecting places for recycling.
• Do not insert flat batteries.
• Only use the type of batteries indicated.
Press the ON/OFF button to turn ON the
remote control and it’s ready to work.
NOTE: up to 6 remote controls can be
programmed for one single water heater,
each with a range distance of 30m.
CAUTION:
remote control is not a toy - do not allow
children to play with the remote control unit.
CAUTION:
remote control can be used under the
shower , however, it’s immersion must
not be forced .
To Next Page
Loading...
