The power tool is intended for sanding and brushing wood, plastic, metal, filler (e.g. plaster) and varnished surfaces
without the use of water. It is especially suitable for sanding uneven surfaces.
Product Features
The numbering of the product features refers to the diagram of the power tool on the graphics page.
1. Grinding spindle
2. Dust extraction guard
3. Extraction outlet
4. Clamping screw for mounting dust extraction guard
5. Handle (insulated gripping surface)
6. On/off switch
7. Speed preselection thumbwheel
8. Flexible wheel
9. Flap wheels
10. Shank for sanding sleevea)
11. Sanding sleevea)
12. SDS mount
13. SDS mounting spring
14. SDS actuator button for unlocking the abrasive tool
15. Tool arm
16. Fastening groove of the dust extraction guard
17. Latching grooves
18. Extraction hose
19. Dust extraction adapter (dia. 19 mm)
Accessories shown or described are not included with the product as standard. You can find the complete selection
of accessories in our accessories range.
Technical Data
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in
country-specific models.
Noise/Vibration Information
Noise emission values determined according to
EN 62841-2-4.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level 79 dB(A); sound power level 90 dB(A). Uncertainty K = 3 dB.
Wear hearing protection
Total vibration values ah (triax vector sum) and uncertainty K determined according to EN 62841-2-4:
Sanding with sanding sleeve: ah = 3.5 m/s2, K = 1.5 m/s2, Sanding with flap wheel (60 mm): ah = 2.5 m/s2,
K = 1.5 m/s2, Sanding with flap wheel (10 mm): ah = 3 m/s2, K = 1.5 m/s2, Working with wire brush: ah = 6 m/s2, K =