To start the power tool, slide the on/off switch (6) forwards.
To lock the on/off switch (6) in position, push the on/off switch (6) forwards until it clicks into place.
To switch off the power tool, release the on/off switch (6); or, if the switch is locked, briefly press the on/off
switch (6) backwards and down and then release it.
Always check abrasive tools before using them. The abrasive tool must be fitted properly and be able to
move freely. Carry out a test run for at least one minute with no load. Do not use abrasive tools that are
damaged, run untrue or vibrate during use. Damaged abrasive tools can burst apart and cause injuries.
Selecting the abrasive tool
Choose the abrasive tool based on the surface shape and material you want to sand. Select an appropriate grit for
the required material removal rate.
To Next Page
Loading...
