Bosch TRANSFLOW j-45096

Questions and Answers

M
Mary HicksAug 3, 2025
What to do if the 'FLOW < 0.5 GPM' message appears on my Bosch Measuring Instruments?
- W
  wolfepaulaAug 3, 2025
  If the 'FLOW < 0.5 GPM' message appears on the graphic LCD of your Bosch Measuring Instruments, it could be due to a restriction in the vehicle's T.O.C. system or transmission cooler lines. Try following the Flush Operation/Flow Test procedure. Also, check that the shop air supply is greater than 90 PSI and that the air supply hose is connected to the unit. If problems persist, perform a self-test. If the self-test fails, adjust the TransFlow internal pressure regulator.
A
Allen MartinezAug 8, 2025
What does it mean when the 'LOW VOLTAGE' message appears on my Bosch TRANSFLOW j-45096 Measuring Instruments?
- J
  johnny39Aug 8, 2025
  If the 'LOW VOLTAGE' message appears on the graphic LCD of your Bosch Measuring Instruments, it means the unit is receiving less than 11V DC. To solve this, charge and test the vehicle battery. Also, check for secure battery + and vehicle ground connections.
M
Mary BoothAug 14, 2025
What to do if the 'TANK EMPTY' message appears on my Bosch TRANSFLOW j-45096?
- T
  Tammy BarronAug 15, 2025
  If the 'TANK EMPTY' message appears on the graphic LCD of your Bosch Measuring Instruments, it indicates that the supply vessel is empty. To resolve this, add the appropriate amount of ATF to the supply vessel.
M
Madison AguilarAug 21, 2025
What does the 'LOW FLUID TEMP' message mean on my Bosch TRANSFLOW j-45096?
- B
  Beverly SmithAug 21, 2025
  If the 'LOW FLUID TEMP' message appears on the graphic LCD of your Bosch Measuring Instruments, it means the supply ATF is below 65 degrees Fahrenheit. Warm up the supply ATF to 65° F to resolve this issue.
C
Clayton SullivanAug 27, 2025
How to troubleshoot a Bosch TRANSFLOW j-45096 Measuring Instruments when the LCD doesn't turn on?
- J
  Jake AvilaAug 27, 2025
  If the main power switch is on but the graphic LCD doesn't turn on for your Bosch Measuring Instruments, the issue might be with the power supply. First, ensure the power supply cable is properly connected to the battery. Then, check the connection at the positive terminal and chassis ground. Also, verify the polarity of the battery clamps and make sure the battery is fully charged.