Bosch UniversalMulti 18V-32 - Page 19

English | 19
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
Only store the battery within a temperature range of −20 to
50°C. Do not leave the battery in your car in the summer, for
example.
Occasionally clean the ventilation slots on the battery using a
soft brush that is clean and dry.
A significantly reduced operating time after charging indic-
ates that the battery has deteriorated and must be replaced.
Follow the instructions on correct disposal.
Assembly
u Remove the battery from the power tool before carry-
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
moved for transport and storage. There is risk of injury
from unintentionally pressing the on/off switch.
Changing the tool
u Wear protective gloves when changing accessories.
There is a risk of injury when touching the accessories.
Selecting an Accessory
Please observe the accessories intended for your power
tool.
Accessory UniversalMulti18V-32
The following table shows examples for accessories. You can find additional accessories in Bosch’s extensive range of ac-
cessories. The potential applications and the materials that can be processed vary depending on the type of accessory.
Application tool Application examples
Segment saw blade Separating cuts and plunge saw cuts;
including sawing close to edges, in corners and in difficult-to-reach areas.
Example: Shortening door frames or skirting boards that are already in-
stalled, plunge cuts when adapting floor panels
Sanding plate for
Delta series 93mm
sanding sheets
Sanding surfaces at edges, in corners or in difficult-to-reach areas;
depending on the sanding sheet, e.g. for sanding wood, paint, varnish,
stone
Profile sander Comfortable and efficient sanding up to a diameter of 55mm.
Example: Pipes and profiles
Plunge cut saw
blade
Separating cuts and plunge saw cuts.
The cutting depth and cut size and the material that can be processed vary
depending on the type of plunge cut saw blade.
HM-Riff mortar
remover
Routing and cutting of joint material and tile material, as well as rasping and
sanding on a hard surface.
Example: Removing tile adhesive and joint mortar
HCS multi blade Fast and precise cutting of soft material and flexible abrasive materials.
Example: Cutting carpets, cardboard, PVC flooring, roofing felt, etc.
Scraper, rigid Scraping on a hard surface.
Example: Removing mortar, tile adhesive and carpet adhesive residue
Scraper, flexible Flexible scraping on a soft surface.
Example: Removing silicone joints, carpet adhesive residue and paint
residue
Bosch Power Tools 1 609 92A 87V | (07.12.2023)