12 en | Installing the Fiber Optic Module Fiber Optic Media Converter
F.01U.134.924 | 1.0 | 2009.09 Installation Guide Bosch Security Systems, Inc.
12. Connect the RJ45 Ethernet patch cable (blue) to its socket
on the fiber optic module. Then attach the other end to the
female mating connector in the AutoDome pendant arm.
Note: If installing a Pipe or Roof mounted AutoDome, you
will need to provide the appropriate length Ethernet cable
with RJ45 connectors to reach between the AutoDome and
the power supply box.
13. Route the appropriate fiber optic cable through the
conduit hole on the power supply box.
14. Plug the fiber optic cable (LC or SC connector) into the
SFP module inside the power supply unit.
15. Close and secure the power supply box when finished.
16. Restore the power to the power supply box.
To Next Page
Loading...
Need help?
General
