Safety systems
Safety systems
Start lock-out and
automatic cut-out
blender jug has been correctly positioned
and if the rotary selector is turned to
appliance or after an interruption in the
automatically if the blender jug becomes
(speed min – max) after 5½ minutes of
continuous operation. X
Overload protection
appliance overheats. X
Note:
protection, a slightly strange smell may
Troubleshooting
W Risk of injury!
mains plug.
Note:
operation, if the electronic fuses trip or the
appliance has a defect. First try to eliminate
Caution!
If a fault cannot be eliminated, please
contact customer service.
Fault
Possible causes
– Blender jug is not correctly positioned,
has become detached or has been
removed.
–
–
continuously in manual mode (speed
min – max) for longer than 5½ minutes.
Remedy
Position the blender jug correctly.
(zero setting).
Fault
Possible cause
Remedy
(zero setting).
Remove the blender jug.
Leave the appliance to cool for approx.
again.
If the appliance does not start, turn the
button on the bottom (X Fig. A - 1c).
If the reset button is blocked, leave the
appliance to cool again and try it again
later.
To Next Page
Loading...
