14 en | Installing and connecting VOT-320
F.01U.266.039 | V5.5 | 2012.03 Quick Installation Guide Bosch Sicherheitssysteme GmbH
4.8 Connecting the power supply
– Connect the power supply unit cables to the terminal
block.
– Connect the terminal block to the orange socket on the
VOT-320.
– Insert the power supply unit plug into a suitable socket.
CAUTION!
Only operate the VOT-320 in combination with a SELV power
supply unit that meets the following specifications: 24 VAC
output voltage, min. 33.6 VA without pan/tilt.
Please observe the labeling on the camera module of the
VOT-320 and the correct position for the terminal block.
To Next Page
Loading...
