de Environmental protection and saving
▶ No hard abrasive pads or
Use cleaning sponges.
▶ The device only with water and a
clean with a soft, damp cloth.
If you come into contact with the device,
immediately remove all detergent
residues, spray residue or residues.
Reduce the washing temperature for
lightly and normally soiled laundry.
a At lower temperatures
the device uses less energy. For
light to normal soiling,
temperatures lower than those
indicated on the care label are
sufficient.
▶
U 3Environmental protection and savings
Environmental protection and
Save
Set the maximum spin speed if the
laundry is then to be dried in the
tumble dryer.
Environmental protection and saving
3.1 Dispose of packaging
a Dryer laundry shortens the time
Program duration while drying and
reduces energy consumption. As
the spin speed increases, the
residual moisture in the laundry
decreases and the volume of the
spinning noise increases.
The packaging materials are environmentally
friendly and can be recycled.
▶ The individual components
Dispose of separately according to type.
3.2 Saving energy and
resources
Wash laundry without prewash.
a The washing with prewash is
extends the duration of the
program and increases energy
and water consumption.
If you follow these guidelines, your
device will use less electricity and
water.
Use programs with low temperatures
and longer washing times and the
maximum load →
Page 26
exploit.
The device has an automatic quantity
control.
a The automatic amount fits that
The water consumption and the program
duration are optimally adapted to the type
of textile and the amount of load.
a The energy consumption and water
water consumption is the most efficient.
Dose detergent according to the
degree of soiling of the laundry →
Page 37.
3.3 Energy saving mode
If you do not operate the device for a
long time, the device automatically
switches to energy-saving mode. All
displays go out and
a For light to normal soiling
a smaller amount of detergent is
sufficient. Follow the detergent
manufacturer's dosage
recommendations.
Start / reload flashes.
The energy-saving mode is ended by
operating the device again, e.g. B.
open or close the door.
12th
To Next Page
Loading...
