de Basic operation
13.7 Start the program 13.10 Adding laundry
Note: If you want to change the time
until the end of the program, first
set the Ready in time.
Note: Note the information on
security
→
page 4
and avoid damage to property.
the →
Page 11,
to use your device
safely.
▶ on Start / reload to press.
a The drum turns and it
a load detection follows, which
can take up to 2 minutes and then
the water runs in.
a The display shows either pro
duration or the Ready in time is
displayed.
a The display shows after program
end: "End".
1. on Start / reload to press.
The machine pauses and checks
whether you can add or remove
laundry. Note the program status.
2. Add or remove laundry.
3. Close the door.
13.8 Adjust the finished in time
before starting the program
4th on Start / reload to press.
13.11 Cancel the program
You can adjust the set Ready in time
again before the program starts.
After the program has started, you can
cancel the program at any time.
1. on Start / reload to press.
Note: Note the information on
security
→
page 4
and avoid damage to property.
the →
Page 11,
to use your device
safely.
2. on Completed in Press until the
display shows the required finished in
time.
3. on Start / reload to press.
1. on Start / reload to press.
13.9 Soaking laundry
2. Open the door.
You can soak the laundry in the
appliance before washing by pausing
the program.
At high temperatures and high
water levels, the door remains
locked for safety reasons.
- If the temperature is high, start
the program Wash .
- If the water level is high, start the
program sling
Note: No additional detergent is
necessary. The detergent solution is
then used for washing.
or Pumping out.
1. Start the program.
3. Remove the laundry.
2. To pause the program, open after
approx. 10 minutes Begin /
13.12 Continue program
with rinse hold
Reload to press.
3. To continue the program after the
desired soaking
1. The program sling or
Pumping out to adjust.
time on Start / reload to press.
2. on Start / reload to press.
40
To Next Page
Loading...
