Bosch WFMC64 - Washer Disassembly Procedures; Fascia Panel Disassembly

Rev 0 (1/17/08)
2
Disassembly
Disassembly
–
–
Fascia (Control) Panel (1)
Fascia (Control) Panel (1)
To remove fascia panel to access control module & dispenser, remove (4) T-20 Torx front/side screws and lift
panel up. Caps over screws can be removed using fingernails or a sharp knife – take care not to scratch
fascia panel or caps.
Knobs are permanently attached to
panels and cannot be removed.
When reassembling
panels, tuck rear
tabs under top
panel 1
st
.
T-20 screws
702_58300000133618_ara_en_a