Bosch Whyte E-180 - Out the Box

When unboxing your new Whyte Bicycle you will nd an accessories
box/case containing numerous manuals (Including this manual). Please
ensure you read all relevant literature prior to assembly or riding your
bicycle. Relevant manufacturer manuals for your bicycle’s components
will be provided. Ensure all documents are retained for assistance with
maintenance, cleaning, and warranty.
Please note: the Whyte accessories box/case will differ between bike
models and may not reect the illustrations in this manual. Please refer
to the ‘Tools’ section of this manual for the recommended equipment.
If you have purchased an eBike please take care when handling and
storing electrical components.
7
Tools Required
• 15mm Spanner
• Philips Head Screwdriver
Accessory Part Instructions:
In the bicycle accessories kit you will nd numerous components
relevant to your bicycle. If your bicycle is supplied with pedals you
will need a 15mm spanner to t them to the cranks. Ensure you have
identied the right and left pedal prior to installation. Tighten pedals to
a recommended 40.2-42.9 Nm (350-380 lb/in). When installing pedals
coat threads with assembly lubricant and pay attention to differing
thread directions.
A Philips screw driver is required to mount reectors to your bicycle.
Reectors are a crucial part of the safety system and must not be
removed. Before riding your Whyte eBike please inform yourself of all
applicable legal requirements to ride safely in your country/state.
OUT THE BOX