Bosch WHYTE E-Lyte 140 - Page 14

02 - RIDE INFO 2.4 After a Crash
AFTER A CRASH
Crashing and falling off your bike is part of cycling. Check yourself for
injuries. Take care of them as best you can. If necessary, seek medical
help. An apparently minor incident could have major implications later
on.
WARNING:
Carbon composite components, including frames, wheels,
handlebars, stems, crank-sets, brakes, etc. which have
sustained an impact must not be ridden until they have
been disassembled and thoroughly inspected by a
qualied mechanic.
Ensure a thorough check of the complete bike is completed before riding
the bike after a crash/fall. Damage might be obvious like a cracked frame,
forks, or bent handlebars. Less obvious damage like bent or twisted
controls on the handlebar can affect handling of the bike and will need
to be rectied. Please go through the ‘Pre-Ride’ checks supplied in this
manual. Carefully examine all areas of the frame, forks, and rims for
any dents, cracks or deformations. If you nd any signs of damage to
the frame, forks, or rims then do not ride the bike. Consult your Whyte
retailer to have the bike thoroughly inspected before riding the bike
again.
Check the seat, seat-post, stem, and handlebars are still in the correct
orientation. NEVER try to correct the position by force. Loosen xings/
bolts with the correct tools and reposition before re-tightening (Ensure
you refer to the specied torque settings).
Check both wheels are securely tted in the right position in the frame
and fork. Lift the eBike at both the front and rear to test the wheels
rotate freely. Make sure there are no dents or deformations to the rims.
Ensure the wheel runs true with no interference from the frame. Be sure
to check over brake alignment with discs and pads as this may have
been altered in the crash. Failure to carry out these checks before riding
puts the rider at risk.
WARNING: Aluminium components when deformed can break
unexpectedly. If any of your Whyte bicycle components have
been deformed or bent after a fall then the bicycle is unsafe to
ride. Please ensure damaged parts are replaced and correctly
installed. If there is any doubt do not ride your bicycle and
contact your Whyte retailer for support.
14
WARNING: A collision or impact can cause serious damage to
your bicycle and its components, causing them to malfunction
or wear out prematurely. Malfunctions can occur suddenly and
without notice, causing you to lose control of your bicycle and
suffer serious injuries,
If you discover any damage to your Whyte bike or its components, STOP
using the bicycle immediately!
Even if you can not visually observe any damage, pay close attention to
the sound of your bicycle when riding. Unusual noises or riding vibrations
can be a clear sign of damage and you should stop riding immediately.
Contact your Whyte retailer who will be able to correctly diagnose the
problem.